Making a Robot With Arduino Part 2: Assembly

Sorry for taking so long, there is a lot of picture here.

After showing the motor controller last week, we can start making the robot.

Step 0

Robot Base

This is the robot base, bare only with motor and wheels.

Step 1

Robot base Rearrange Wire

Notice the hole, it is used to screw in the board and component, and a place to arrange the wire around to make things neat. The wire put in a way we can put it into the motor controller neatly.

Step 2

First Screw Into the hole

Put the motor controller on the side, where we have arrange motor wire. Under it there is some fasteners already in place. First screw in the first screw into the pre positioned fasteners. Then from it, rearrange the rest of the fasteners, to make fastening of the screw easier.

Installed motor controller

It should look this way

Step 3

Motor Wire

Twist the wire a bit, to make it easy to install into the terminal

Install motor to terminal

Just unscrew the terminal abit, and install the wire, and screw it back. Don’t worry about the direction. If the motor turn reversed. Just reverse the order of wire.

Now do the same for the other motor, on the terminal opposite of this one.

The robot minus arduino

The robot now should look this way

Step 4

Install the arduino

Now we can install the arduino. There is fastener that I already put in a hole on the robot, to make screw it easy. There is a few hole on the robot, just install into one that fit. You don’t need to screw into all the screw holes on the arduino. Just make sure it secure in place.

Mounted arduino

It should be around that way.

Step 5

Now we can start wire up everything.

The arduino wire goes here

There is a few terminal on that side of the robot. The top 3 pin is the control for one side of the motor, the bottom 3 is for the other side. The middle one is the power for the motor and motor controller

Page 1 of 4 | Next page